Being one of the best copiers in the market for several years, the Sharp AL-2030 copiers will display some error with time.
This post will teach you all you need to know about eradicating the E7-11 error message on Sharp AL-2030 copiers in four easy steps.
Being one of the best copiers in the market for several years, the Sharp AL-2030 copiers will display some error with time, if you own this copier and it is working perfectly you can still save this article somewhere for future reference.
We looked this error up in the Sharp Trouble Error & Codes manual, where we found a solution to this same issue. It’s very important to identify the error subcode on your Sharp copier, as you can see there are multiple errors in the E7 error message column, each code is related to one function, one problem and one solution for it.
Step 3:
After this procedure has been finished, turn the scanner on. It will show the F5 error message, which indicates the crystal is now loose, this is okay since we’re actually working on the scanner.
In case you don’t want this error message to appear, simply place the crystal back on the scanner. However, recommend you put this off if the E7 error persists.
Step 4:
Place every piece back where they belong, then test the device to see if the error was successfully eliminated.
This post shows only one solution to this problem and it does not mean it is the only solution available to eliminate this error. If you know a different way to eliminate this error please leave a comment below.
Being one of the best copiers in the market for several years, the Sharp AL-2030 copiers will display some error with time, if you own this copier and it is working perfectly you can still save this article somewhere for future reference.
 |
| sharp printer preparing process |
Steps to follow to eradicate this issue:
According to the manual, this error originates in the scanner’s lamp, or in the scanner’s roller, which could be jammed.
Step 1:
Clean the scanner’s lamp as softly as possible, keeping it from breaking because it is a very delicate bulb. We suggest you use napkins for this, and a small vacuum or blow dryer to clean out all paper residues that may lay inside. If anything is left inside the lamp, it will appear on every single copy you scan or copy.
Step 2:
Grease up the scanner’s roller located in the scanning sector; it will allow it to move from one side to the other.Step 3:
After this procedure has been finished, turn the scanner on. It will show the F5 error message, which indicates the crystal is now loose, this is okay since we’re actually working on the scanner.
In case you don’t want this error message to appear, simply place the crystal back on the scanner. However, recommend you put this off if the E7 error persists.
Step 4:
Place every piece back where they belong, then test the device to see if the error was successfully eliminated.
This post shows only one solution to this problem and it does not mean it is the only solution available to eliminate this error. If you know a different way to eliminate this error please leave a comment below.
COMMENTS